The note duration was correct, but apparently when I examined the 6/8 measure's components (beat duration), it was reading it with eight beats instead of six. I manually corrected the measure, and ...
Thank you for the suggestion, Michel, and I tried what you wrote, but it does not work in the least. Might there be a glitch in the program, or something I did that set this measure to look like th...
I did, until I went back and found the problem, namely in the notes themselves. Went to the reverse stem tool, fixed some notes and then went to Beam Angle Tool which, this time, did work. Problem ...
No. 2 - there is no handle on the beam whatsoever. I've clicked the beam incessantly and no handle (little box) for me to move the beam.
I did that, and no go. I wish I could give you a screen shot or send you the file so you can see what I am up against, but...Suffice it to say, I am frustrated.
I've done that, and no handle whatsoever. Perhaps it's because I used the cross-staff part a bit too much?
Apparently this may be the right page to come to. I am running into a similar problem. I extracted my parts, edited them and saved them. When I went to print them using a PDF program, I wound up wi...
This may be the wrong place to post my concerns, but...here goes.I'm printing my extracted parts to PDF files, and in the case of the trombone parts, instead of getting the one page or two pages of...