Kevin Scott commented,
The note duration was correct, but apparently when I examined the 6/8 measure's components (beat duration), it was reading it with eight beats instead of six. I manually corrected the measure, and ...
Kevin Scott commented,
Thank you for the suggestion, Michel, and I tried what you wrote, but it does not work in the least. Might there be a glitch in the program, or something I did that set this measure to look like th...
Kevin Scott created a post,
I am in the process of engraving an old work of mine, and one of the measures (third to last on this page) is totally out of shape when compared to the other measures (It is totally longer than the...
Kevin Scott commented,
I did, until I went back and found the problem, namely in the notes themselves. Went to the reverse stem tool, fixed some notes and then went to Beam Angle Tool which, this time, did work. Problem ...
Kevin Scott commented,
No. 2 - there is no handle on the beam whatsoever. I've clicked the beam incessantly and no handle (little box) for me to move the beam.
Kevin Scott commented,
I did that, and no go. I wish I could give you a screen shot or send you the file so you can see what I am up against, but...Suffice it to say, I am frustrated.
Kevin Scott commented,
I've done that, and no handle whatsoever. Perhaps it's because I used the cross-staff part a bit too much?
Kevin Scott created a post,
Hello! I am having a dickens of a time trying to get the beam angle tool to cooperate, When I click on the handle to see the prompt...nothing. I have tried incessantly, but to no avail. Short of un...
Kevin Scott commented,
Apparently this may be the right page to come to. I am running into a similar problem. I extracted my parts, edited them and saved them. When I went to print them using a PDF program, I wound up wi...
Kevin Scott commented,
This may be the wrong place to post my concerns, but...here goes.I'm printing my extracted parts to PDF files, and in the case of the trombone parts, instead of getting the one page or two pages of...